Products

• Easy application and better workability
• Excellent adhesion, non-shrinkage
• Excellent waterproofing characteristics
• High strength
• Good open wet time
• It needs no curing or soaking of the tiles

• The surface should be sound and clean, free from dust, grease, oil, loose material, or paint
• The movement joints are to be filled with a suitable joint filler
• The surface must be in SSD condition before application

• Mix a 20-kg bag of PG-400 and W-400 in approximately 6 to 6.5 liters of clean water and mix thoroughly until a slump-free mortar is achieved
• Mix with a trowel or slow-speed drills for a homogeneous mix
• Allow it to slake for 5 minutes
• Mix the required quantity, which can be used within the desired pot life, not exceeding 1 m2

• Spread the adhesive uniformly on the surface as required with a proper notch trowel to get the required depth of 6–12 mm
• Place the tile on the adhesive surface and press firmly into position with a slight twisting action
• Ensure that good contact is maintained with the back of each tile, eliminating the possibility of any air voids
• Tiles should be applied within 15 to 20 minutes of the adhesive being applied
• Keep adequate joints between two tiles using spacers
• Clean off surplus adhesive from the tile face and between joints

• Always add powder to water, and never add water to powder
• Never add more water than is recommended
• The surface should be hard and in sound condition for floor tiling
• Do not use it in damp conditions
• It is not recommended for tiling on paint, wood, metal or gypsum

30-35 sq. ft. for a 20kg bag at 6mm thickness may vary upon notch trowel size at site condition.

Shelf life is one year from the manufacturing date. Store the material in a cool, dry place away from moisture.

All technical data stated in this product data-sheet is based on laboratory tests. Actual measured data may vary due to circumstances beyond our control.

For information and advice on the safe handling, storage, and disposal of chemical products, users shall refer to the most recent material safety data sheet containing physical, ecological, toxicological, and other safety-related data.