Products

• No vertical slipping
• Extended open time
• Frostproof
• One-pack
• It can be applied up to 10 mm thick
• Can be applied to cement waterproofing mortars
• It needs no curing or soaking of the tiles

• The surface should be sound and clean, free from dust, grease, oil, loose material or paint
• The movement joints are to be filled with a suitable joint filler
• The surface must be in SSD condition before application

• Mix 20kg of PG-600 and W600 in approximately 6.5 to 6.75 liters of clean water and mix thoroughly until a slump-free mortar is achieved
• Mix with a trowel or slow-speed drills for a homogeneous mix
• Allow it to slake for 5 minutes
• Mix the required quantity, which can be used within the desired pot life, not exceeding 1 m2

• Spread the adhesive uniformly on the surface as required with a proper notch trowel to get the required depth of 6-12 mm
• Place the tile on the adhesive surface and press firmly into position with a slight twisting action
• Ensure that good contact is maintained with the back of each tile, eliminating the possibility of any air voids
• Tiles should be applied within 15 to 20 minutes of the adhesive being applied
• Keep adequate joints between two tiles using spacers
• Clean off surplus adhesive from the tile face and between joints

• Always add the powder to the water and never add water to the powder
• Never add more water than is recommended
• The surface should be hard and in sound condition for floor tiling
• Do not use in damp conditions
• It is not recommended for tiling on paint, wood, metal or gypsum

30-35 sq. ft. for a 20kg bag at 6mm thickness may vary upon notch trowel size at site condition.

Shelf life is one year from the manufacturing date. Store the material in a cool, dry place away from moisture.

All technical data stated in this product data-sheet is based on laboratory tests. Actual measured data may vary due to circumstances beyond our control.